STEP 1. Lift and remove the actual toilet seat by removing the screws that holds  it.		STEP 6B. Flush the toilet.
	STEP 2. Install the"HOLDING"HOLDING PLASTIC  PLATES" to the Bidet back area (rear). Make sure the plates can slide in or out about one inch in order to adjust them to the Toilet installation Area.		STEP 6C. Disconnect the hose that is presently connected underneath the toilet tank.
	STEP 3. By holding the bidet in the air, obtain the correct measurement by aligning the screws to the two toilet holes. Make sure that plastic screws coincide with the toilet holes.		STEP 6D. Connect the ( T ) 7/8 fitting to the tank.
	STEP 4. Tight and hold permanently the "HOLDING PLASTIC PLATES" to the selected position using the metallic screws that are temporary holding them.		STEP 6E. Reconnect the hose (removed in STEP 6C). to   the ( T ).
	STEP 5. Place the Sofflow Bidet on top of the toilet. Insert the plastic screws in the toilet holes and proceed to fight the plastic screws and knob. DO NOT OVER SCREW THEM/USE TOOL INCLUDED).		STEP 6F. Use the enclosed while transparent hose and introduce one end  of it in the push-in valve. Make sure to twist the hose about 30 degree while pushing it in. This technique will avoid water leaking.
	STEP 6A. Close the toilet water supply.		STEP 6G. Repeat the same step with the order end of the hose but this time the other end will be inserted the toilet seat valve (mater mixer)blue color.